Payment & Shipping Terms:
|Standard:||AISI, ASTM, BS, DIN, GB, JIS||Thickness:||3-16mm|
|Loading Port:||Shanghai||Surface:||BA, No 1, No 2D, 2B, NO. 3, NO. 4, HL, BA, 8K,|
stainless steel sheet metal,
Customized Stainless Steel Metal Sheet Brightness And Flatness Surface
Stainless Steel Metal Sheet Introduction:
Stainless Steel Metal Sheet is iron-base alloys that contain a minimum of about 12% Cr,the amount needed to prevent the formation of rust in unpolluted atmospheres (hence the designation stainless). Few stainless steels contain more than 30% Cr or less than 50% iron.They achieve their stainless characteristics through the formation of an invisible and adherent chromium rich oxide film. This oxide forms and heals itself in the presence of oxygen. Other elements added to improve particular characteristics include nickel, manganese, molybdenum, copper, titanium, silicon, niobium, aluminum, sulfur, and selenium. Carbon is normally present in amounts ranging from less than 0.03% to over 1.0% in certain grades.
|Product Description:||Stainless Steel Metal Sheet|
|Grade:||201(halft copper/Full copper), 301, 304, 304L, 316, 316L,409, 409L, 410L, 430, 410, 420|
|Type:||Cold Rolled/hot rolled|
|Brand Name:||Wuhang; Dingxin; Baosteel; TISCO, Yongjin, POSCO|
|Material:||AOD or Induction|
|Finish Surface:||BA, No 1, No 2D, 2B, NO. 3, NO. 4, HL, BA, 8K,|
|Thickness:||0.15mm - 1.5 mm (tolerances +/-0.01mm)|
|Width:||30mm-860mm, or customized (tolerances +/-0.01mm)|
|Edge:||Slit Edge/Mill Edge|
|Annealed:||Full hardness to Deep drawing quality (DDQ)|
|Supply Ability:||3000 Tons per Month|
|Certificate:||Testing report / MTC|
|Application:||Utensil, kitchenware,tableware, etc|
|Export Market:||India, Pakistan, Thailand, Syria, Bangladesh, South Korea etc|
|Samples:||Samples free and express charges bear by buyer|
Different Finished Surface Characteristic:
No 1: Some of the thinner thicknesses within the plate range are Cold Rolled; but Sheet, Coil and Strip gauges are produced by Cold Rolling, ie rolled without and heating of the material. Cold Rolling hardens the material, and the thinner sizes may have to be subjected to an intermediate anneal and pickle, or bright annealed, during the reduction of thickness to final gauge The starting material for Cold Rolling always has a No. 1 finish. Cold Rolled material is supplied with the following standard mill finishes.
No 2A: A no. 1 Finish after being Cold Rolled, Annealed, Pickled and Passivated. This results in a uniform dull matt finish, superior to a No. 1 Finish. Suitable for industrial application, and eminently suitable for severe deep drawing as the dull surface, (which may be polished after fabrication) retains the lubricant during the drawing operation.
NO. 2B: The surface brightness and flatness of no2B is better than no2D. Then through a special surface treatment to improve its mechanical properties, No2B could nearly satisfy comprehensive uses.
NO. 3: Polished with abrasive belt of git#100-#200, have better brightness with discontinuous coarse stria, used as inner and external ornaments for building, electrical appliances and kitchen utensils etc
Hot rolled coil:
Cold rolled sheet:
Contact Person: Bin Pan